Rock Pillar Silicone Mould — for Resin, Wax & Clay

This rock-pillar mould creates a rugged, stone-inspired cylinder that reads beautifully across candle wax, resin, and clay. With six cavities—each about 6 × 6 cm—it’s sized for efficient small-batch production while maintaining crisp texture.

For wax, place the mould on a flat tray, pre-centre a wick pin in each cavity if making free-standing minis, and pour slightly cooler to preserve surface detail; always test-burn for clean melt pools at this diameter.

For resin, brush a thin seal coat to lock in inclusions (gold leaf, shimmer, dried petals), then fill slowly to minimise bubbles along textured walls; avoid aggressive torching to protect the silicone.

For clay (air-dry or polymer), press evenly from the centre out, level the back before release, and add a small hole pre-cure if you want a hanging tag.

Care: rinse with mild soap and water, no abrasives/knives, keep away from direct flame or high heat, and store flat to prevent warping—simple habits that keep impressions sharp pour after pour.